Buderus Logamax plus GB142-60 User Manual

Please read these instructions carefully
Service kit instructions, condensate trap and condensate bypass pipe
Condensing gas boiler
Logamax plus
WARNING!
This service kit shall be installed by a qualified service
agency in accordance with the manufacturer‘s instruc-
tions and all applicable codes and requirements of the
authority having jurisdiction.
The information in these instructions must be followed to
minimize the risk of fire or explosion or to prevent prop-
erty damage, personal injury or death. The qualified ser-
vice agency is responsible for the proper installation of
this kit.
The installation is not proper and complete until the oper-
ation of the repaired appliance is checked as specified in
the manufacturer‘s instructions supplied with the kit.
CAUTION!
Shut off the gas supply prior to disconnecting the electri-
cal power, before starting.
Notice! Save these instructions for later use.
GB142-24/30/45/60
6 720 810 045 (12/2013) US/CA

Buderus Logamax plus GB142-60 Specifications

General

Fuel Type	Natural gas / LPG
Max Operating Pressure	3 bar
Type	Wall-mounted condensing boiler
Efficiency	Up to 109%
Connection Size (Gas)	3/4"

Summary

Safety Considerations

Application Purpose

Describes the intended use of the service kit for the Logamax plus boiler.

Explanation of Symbols

Explains the meaning of graphical symbols used in the document for safety instructions.

Additional Symbols

Details additional symbols used for referencing related parts or list entries.

Observe the Following Warnings

Highlights critical DANGER warnings for gas explosion and electrical shock hazards.

Scope of Delivery

Installation

Shutting Down the Appliance

Details the steps to safely shut down the boiler before starting installation procedures.

Removing the Condensate Trap

Provides instructions on how to detach and remove the existing condensate trap.

Removing the Heat Exchanger

Guides the user through the process of disconnecting and removing the heat exchanger.

Mounting the New Condensate Trap and Flue Gas Adapter

Explains how to install the new condensate trap and flue gas adapter.

Testing for Gas Leaks

Outlines the procedure for checking gas connections for leaks after installation.

Filling the Appliance

Describes how to fill the heating system to the correct pressure.

Start Up the Appliance

Provides instructions for safely starting up the boiler after the service kit installation.