Buderus Logano G215 WS User Manual

6
Operating instructions Logano G215 WS oil/gas-fired special boilers • Issue 02/2006
We reserve the right to make any changes due to technical modifications.
Operation of the heating system3
3 Operation of the heating system
3.1 Switching on the heating system
Before switching the system on, check
– that the operating pressure is high enough,
– that the fuel supply at the main shut-off valve is open
and
– that the heating system emergency stop switch is
switched on.
z Switch the boiler water thermostat to "AUT"
(Automatic).
z Switch the ON/OFF switch to ON (position "I"). This
switches on the entire heating system.
3.2 Switching off the heating system
z Switch the ON/OFF switch on the control to OFF
(position "0"). This switches the boiler and all its
components OFF (for example the burner).
z Close the main fuel shut-off valve.
3.3 Emergency measures
In the event of an emergency, e. g. a fire, proceed as
follows:
z Close the main fuel shut-off valve.
z Isolate the heating system from the mains power
supply via the heating system emergency stop switch
or a corresponding domestic fuse.
Fig. 2 Switching on the heating system (Logamatic 2000)
1 Set the boiler water thermostat
2 ON/OFF switch
Fig. 3 Switching on the heating system (Logamatic 4000)
1 Set the boiler thermostat
2 ON/OFF switch
I
0
1
2
1
2
PLEASE NOTE
Operating instructions, e. g. how to set the
temperature, can be found in the Î control
unit documentation.
CAUTION!
SYSTEM DAMAGE
through frost.
The heating system can freeze up, if it has
been shut down.
z Leave the heating system switched ON
as long as possible.
z Protect your heating system against
freezing by draining the heating
system and DHW pipework at the
lowest possible point.

Buderus Logano G215 WS Specifications

General

Brand	Buderus
Model	Logano G215 WS
Category	Boiler
Language	English