EasyManua.ls Logo

Buell 2006 P3 - Page 45

Buell 2006 P3
419 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2006 Buell P3: Maintenance 1-7
HOME
Table 1-2. Quick Reference Maintenance Chart
ITEM SERVICED SPECIFICATION DATA
Engine oil and filter Drain plug torque plug with spring clamp
Oil capacity 2.0 qt. (1.89 L) Until oil registers between marks
on dipstick.
Filter Hand tighten 1/2-3/4 turn after gasket contact
Black filter part number 63806-00Y
Primary chain tension Deflection with hot engine NONE
Deflection with cold engine Tighten chain limiting screw to 24
in-lbs
(2.7 Nm)
Back-off chain limiting screw 3/4 turn (4 1/2
“flats”).
Chain tensioner nut torque Hold chain limiting screw while tightening jam
nut.
Primary chain inspection cover torque N/A
Primary chain lubricant Lubricant capacity 32 oz. (946 mL)
Primary chaincase drain plug torque 11-15 ft-lbs (14.9-20.3 Nm)
Clutch adjustment Free play at adjuster screw 1/4 - 1/2 turn
Free play at hand lever 0.0625-0.125 in. (1.6-3.2 mm)
Clutch inspection cover torque 84-108
in-lbs
(9.5-12.2 Nm)
Transmission lubricant Lubricant level Inspect fluid level with motorcycle in upright posi-
tion. Level with bottom of clutch shell.
Lubricant capacity 32 oz. (946 mL)
Transmission drain plug torque 11-15 ft-lbs (14.9-20.3 Nm)
Tire condition and pressure Pressure for solo rider Front: 28 psi (1.9 bar)
Rear: 30 psi (2.1 bar)
Pressure for rider and passenger Front: 32 psi (2.2 bar)
Rear: 36 psi (2.5 bar)
Wear Replace tire if 1/32 in. (0.8 mm) or less of tread
pattern remains
Brake fluid reservoir level D.O.T. 4 hydraulic brake fluid part num-
bers
99953-99A (12 oz.)
99973-05 (gal.).
Proper fluid level 1/8 in. (3.2 mm) from the top
Master cylinder reservoir cover torque 9-13
in-lbs
(1.0-1.5 Nm)
Brake pad linings and discs Minimum brake pad thickness 0.1 in. (2.5 mm) or less
Minimum brake disc thickness 0.180 in. (4.5 mm)
Drive belt Upward measurement force applied at
midpoint of bottom belt strand
10 lb. (4.5 kg)
Belt deflection with motorcycle on jiffy
stand and a 160 lb. rider or equivalent
weight sitting on the motorcycle.
Maximum allowable deflection is 0.5 in. (12.7
mm) at the bottom strand.

Table of Contents