Draining
Excess water generated during the operation of the machine will be automatically removed via the drain.
At the end of each day the door should be left open to drain and dry. Before the machine is turned off at the end
of the day the boiler water must be completely drained.
Models without Drain Pump (Drain by Gravity)
Turn off the appliance from the control panel. Open the appliance’s door and remove the drain plug in the tank. Now,
machine will start draining. Once draining is complete, re-place the drain plug.
Models With a Drain Pump
In each operation, the drain system is automatically activated when the rinsing cycle is started.
Before turning off the unit at the end of the day the unit should be drained. Press the drain symbol and
remove the plug. Press to confirm and drainage operation will start automatically. After discharge time is finished,
the drain pump will stop automatically. After finish the drain process press the ’On/Off’ switch to the turn off the
machine.
Note: Once draining is complete, it is recommended to disconnect mains water and electrical supply, and clean the
appliance as described. For a more hygienic operation, leave the appliance door open after the draining process to
ensure that boiler is naturally dried.
To Next Page
Loading...
