V5 INFINIUM Controls
Step 2: Controls
VOLUME – Adjusts the overall volume output of the speaker or headphones.
REVERB – Adjusts the amount of reverb effect.
INPUT – Connect your guitar to this jack.
GAIN – Adjusts the amount of input gain, harmonics and overdrive.
TONE – Adjusts the tonal character of the guitar tone.
POWER – Turns the amp on and off. The lamp lights when power is on and it flashes to indicate an error– see Infinium
advice!
INFINIUM ADVICE – When playing excessively beyond the amp’s maximum power capacity, the infinium regulator may
struggle to correctly adjust the bias. This may cause the Infinium LED on the rear panel to light up and the front
panel power lamp to flash, falsely indicating an error. Both alerts will disappear after a brief pause in playing. If the alerts
persist, replace the EL84 power tube or have the amp checked by a technician. Consider that the power attenuator will
To Next Page
Loading...
