How to Check Power Steering Fluid
To check the power steering fluid, do the following:
1. Turn the key off and let the engine compartment
cool down.
2. Wipe the cap and the top of the reservoir clean.
3. Unscrew the cap and wipe the dipstick with a
clean rag.
4. Replace the cap and completely tighten it.
5. Remove the cap again and look at the fluid level on
the dipstick.
If your vehicle has the 3.8L V6 engine or the
5.3L V8 engine, the fluid level should be between the
ADD and HOT marks when the engine is cold, and
at the HOT mark when the engine is hot. If the fluid is
at the ADD mark when the engine is cold or hot,
power steering fluid should be added.
If your vehicle has the 3.6L V6 engine, the fluid level
should be between the Min (Minimum) and Max
(Maximum) marks when the engine is cold, and at the
Max mark when the engine is hot. If the fluid is at the
Min mark when the engine is cold or hot, power steering
fluid should be added.
What to Use
To determine what kind of fluid to use, see
Recommended Fluids and Lubricants on page 6-12.
Always use the proper fluid.
Notice: Use of the incorrect fluid may damage your
vehicle and the damages may not be covered by
your warranty. Always use the correct fluid listed in
Recommended Fluids and Lubricants on page 6-12.
Windshield Washer Fluid
What to Use
When you need windshield washer fluid, be sure to read
the manufacturer’s instructions before use. If you will
be operating your vehicle in an area where the
temperature may fall below freezing, use a fluid that has
sufficient protection against freezing.
5-44
To Next Page
Loading...
Need help?
General
