Buick Envista Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-18181221) - 2025
250 Vehicle Care
•
W
hen heavily soiled, use warm
soapy water.
Vinyl/Rubber
If equipped with vinyl floor and rubber floor
mats, use asoft cloth and/or brush dampened
with water to remove dust and loose dirt. For
more thorough cleaning, use amild soap and
water solution.
{ W
arning
Do not use cleaners that contain silicone,
w
ax-based products, or cleaners that
increase gloss on vinyl/rubber floor and
mats. These cleaners can permanently
change the appearance and feel of the
vinyl/rubber and can make the floor
slippery. Your foot could slip while
operating the vehicle, and you could lose
control, resulting in acrash. You or others
could be injured.
Fabric/Carpet/Suede
S
tart by vacuuming the surface using asoft
brush attachment. If arotating vacuum brush
attachment is used, only use it on the floor
carpet. Before cleaning, gently remove as much
of the soil as possible:
•
Gently blot liquids with apaper towel.
Continue blotting until no more soil can
be removed.
•
For solid soils, remove as much as possible
prior to vacuuming.
To clean:
1. Saturate aclean, lint-free colorfast
cloth with water. Microfiber cloth is
recommended to prevent lint transfer to
the fabric or carpet.
2. Remove excess moisture by gently
wringing until water does not drip from
the cleaning cloth.
3. Start on the outside edge of the soil and
gently rub toward the center. Fold the
cleaning cloth to aclean area frequently to
prevent forcing the soil into the fabric.
4. Continue gently rubbing the soiled area
until there is no longer any color transfer
from the soil to the cleaning cloth.
5. If the soil is not completely removed, use
a
mild soap solution followed only by
plain water.
If the soil is not completely removed, it
may be necessary to use acommercial
upholstery cleaner or spot lifter. Test asmall
hidden area for colorfastness before using
acommercial upholstery cleaner or spot lifter.
If ring formation occurs, clean the entire fabric
or carpet.
After cleaning, use apaper towel to blot
excess moisture.
Cleaning High Gloss Surfaces and Vehicle
Status and Radio Displays
Use a microfiber cloth on high gloss surfaces or
vehicle displays. First, use asoft bristle brush
to remove dirt that can scratch the surface.
Then gently clean by rubbing with a microfiber
cloth. Never use window cleaners or solvents.
Periodically hand wash the microfiber cloth
separately, using mild soap. Do not use bleach
or fabric softener. Rinse thoroughly and air dry
before next use.