See your dealer/retailer or a locksmith who can
service PASS-Key
®
III+ to get a new key blank that
is cut exactly as the ignition key that operates
the system.
To program the new key:
1. Verify that the new key has a
1 stamped
on it.
2. Insert the already programmed key in the
ignition and start the engine. If the engine
will not start, see your dealer/retailer for
service.
3. After the engine has started, turn the key to
OFF, and remove the key.
4. Insert the key to be programmed and turn it to
the RUN position within five seconds of the
original key being turned to the OFF position.
The security light will turn off once the key
has been programmed.
5. Repeat Steps 1 through 4 if additional keys
are to be programmed.
If you are ever driving and the security light
comes on and stays on, you may be able to restart
your engine if you turn it off. Your PASS-Key
®
III+
system, however, is not working properly and
must be serviced by your dealer/retailer. Your
vehicle is not protected by the PASS-Key
®
III+
system at this time.
If you lose or damage your PASS-Key
®
III+ key,
see your dealer/retailer or a locksmith who can
service PASS-Key
®
III+ to have a new key made.
Do not leave the key or device that disarms or
deactivates the theft deterrent system in the
vehicle.
113
To Next Page
Loading...
