Windshield Washer
{CAUTION:
In freezing weather, do not use your
washer until the windshield is warmed.
Otherwise the washer fluid can form ice
on the windshield, blocking your vision.
J (Washer Fluid): Press and release this
paddle, located at the top of the turn
signal/multifunction lever, to spray washer fluid
on the windshield. The wipers will clear the
windshield and either stop or return to your preset
speed. For more washer cycles, press and hold
the paddle.
_ (Heated Washer Fluid): The heated
windshield washer fluid system, if your vehicle has
this feature, may be used to help clear ice,
snow, tree sap, or bugs from your windshield.
Sliding the switch on the turn signal/multifunction
lever to this position and then releasing it will
activate the heated windshield washer fluid
system. This activation will initiate four heated
wash/wipe cycles. The first heated wash/wipe
cycle may take up to 40 seconds to occur,
depending on outside temperature. After the first
wash/wipe cycle, it may take up to 20 seconds
for each of the remaining cycles. The heated
windshield washer fluid system may be turned off
at any time by sliding the switch on the turn
signal/multifunction lever to this position again.
When the heated windshield washer fluid system
is activated under certain outside temperature
conditions, steam may flow out of the washer
nozzles for a short period of time before washer
fluid is sprayed. This is a normal condition.
WASHER FLUID LOW ADD FLUID will be
displayed on the Driver Information Center (DIC)
when the washer fluid is low. See DIC Warnings
and Messages on page 223.
168
To Next Page
Loading...
Need help?
General
