REMOTE DOOR UNLOCK
This feature allows you to select the type of
feedback you will receive when unlocking the
vehicle with the Remote Keyless Entry (RKE)
transmitter. You will not receive feedback when
unlocking the vehicle with the RKE transmitter if the
doors are open. See Remote Keyless Entry (RKE)
System Operation on page 96 for more information.
Press the customization button until REMOTE
DOOR UNLOCK appears on the DIC display.
Press the set/reset button to access the settings
for this feature. Then press the customization
button to scroll through the following choices:
LIGHTS OFF: The exterior lamps will not flash
when you press the unlock button on the RKE
transmitter.
LIGHTS ON (default): The exterior lamps will
flash when you press the unlock button on
the RKE transmitter.
NO CHANGE: No change will be made to this
feature. The current setting will remain.
Select one of the available choices and press the
set/reset button while it is displayed on the DIC
to select it.
DELAY DOOR LOCK
This feature allows you to select whether or not
the locking of the vehicle’s doors will be delayed.
When locking the doors with the power door
lock switch and a door is open, this feature will
delay locking the doors until five seconds after the
last door is closed. You will hear three chimes
to signal that the delayed locking feature is in use.
The key must be out of the ignition for this
feature to work. You can temporarily override
delayed locking by pressing the power door lock
switch twice or the lock button on the RKE
transmitter twice. See Delayed Locking on
page 103 for more information.
Press the customization button until DELAY
DOOR LOCK appears on the DIC display. Press
the set/reset button to access the settings for
this feature. Then press the customization button
to scroll through the following choices:
OFF: There will be no delayed locking of the
vehicle’s doors.
ON (default): The doors will not lock until
five seconds after the last door is closed.
NO CHANGE: No change will be made to this
feature. The current setting will remain.
237
To Next Page
Loading...
