Adjusting the Speakers (Balance/Fade)
`
BAL/FADE (Balance/Fade): To adjust the
balance or fade, press the
` button or the
f knob until the desired speaker control label
displays. Turn the
f knob clockwise or
counterclockwise to adjust the setting. The setting
can also be adjusted by pressing either SEEK
arrow,
\FWD, or sREV buttons.
Radio Messages
Calibration Error: The audio system has been
calibrated for your vehicle from the factory.
If Calibration Error displays, it means that the
radio has not been configured properly for your
vehicle and it must be returned to your
dealer/retailer for service.
Loc (Locked): This message displays while the
THEFTLOCK
®
system has locked up the radio.
Take the vehicle to your dealer/retailer for service.
If any error occurs repeatedly or if an error
cannot be corrected, contact your dealer/retailer.
Playing a CD (Single CD Player)
Insert a CD partway into the slot, label side up. The
player pulls it in and the CD should begin playing.
If the ignition or radio is turned off with a CD in the
player, it stays in the player. When the ignition or
radio is turned on, the CD starts playing where it
stopped, if it was the last selected audio source.
When a CD is inserted, the CD symbol displays.
As each new track starts to play, the track number
displays.
The CD player can play the smaller 3 inch (8 cm)
single CDs with an adapter ring. Full-size CDs and
the smaller CDs are loaded in the same manner.
If playing a CD-R, the sound quality can be reduced
due to CD-R quality, the method of recording, the
quality of the music that has been recorded, and the
way the CD-R has been handled. There can be an
increase in skipping, difficulty in finding tracks,
and/or difficulty in loading and ejecting. If these
problems occur, check the bottom surface of the
CD. If the surface of the CD is damaged, such as
cracked, broken, or scratched, the CD does not
play properly. If the surface of the CD is soiled,
see Care of Your CDs on page 274 for more
information.
249
To Next Page
Loading...
