To Next Page

To Previous Page

Page 18

REVIEW RECIPES/MODIFY RECIPES/SET UP NO

NAME COFFEE FLAVORS:

This function has three parts. It allows the opera-

tor to view the brew settings for the various coffee

names programmed into the brewer.

It also allows the operator to modify (change) any

of the BREW VOLUMES, BYPASS PERCENTAGES,

PULSE BREW TIMES, PRE-INFUSION TIMES and

DRIP-OUT TIMES for a particular coffee name pro-

grammed into the brewer.

Finally, this function is used to set up the two NO

NAME coffee BREW VOLUMES, BYPASS PERCENT-

AGES, PULSE BREW TIMES, PRE-INFUSION TIMES

and DRIP-OUT TIMES.

Procedure for reviewing recipes:

1. Press and hold the ® pad until the display reads

SET NEW RECIPES. Release the ®. Press the ®

until the display reads REVIEW RECIPES.

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

P2360

2. Press YES to proceed. The display should now

read NO-NAME LEFT, along with MODIFY, SHOW

and NEXT.

3. Press and release SHOW. The screen will scroll

through all the brew settings for that particular

coffee flavor name. When finished, the display

will return to the coffee name just viewed.

4. To see settings again, press SHOW. To advance

to the next coffee flavor name, press NEXT.

5. To exit, press NEXT until the display reads THAT

WAS THE LAST RECIPE.

6. After 5 seconds, the display will return to the

REVIEW RECIPES screen. Press and release NO

to advance to the next function screen, or press

and release either of the

pads located on the

front switch panel to exit the programming mode

and return to the MAIN SCREEN.

35058 121102

Bunn Dual TF DBC User Manual

Other manuals for Bunn Dual TF DBC