Bunn ITCB - Sprayhead Flow Rate Setting; Sprayhead Flow Rate Adjustment

Page 48
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SPRAY OZ/M
This function allows the operator to view or to enter the
actual fl ow rate coming out of the sprayhead. This is
NOT used to change the actual fl ow rate, but to tell the
internal controller how fast the water is fl owing.
Procedure to adjust the sprayhead fl ow rate set-
ting:
1. Press and hold the right hidden button until the
display reads SET LANGUAGE. Press the right hid-
den button until the display reads SPRAY OZ/M .
The number represents what the brewer thinks is
the fl ow rate out of the sprayhead.
2. If the actual fl ow rate of the sprayhead is known
but is different than the number on the display, use
the (-) and (+) to enter the correct fl ow rate.
3. When fi nished, press and release DONE. This saves
the new setting and advances to the next function
screen, DILUTE OZ/M. To exit programming and
return to the MAIN SCREEN, press and release the
ON/OFF pad.
P2877
BREW
A
BREW
B
BREW
C
BREW
A
BREW
C
DILUTE OZ/M: XX.X
(-) DONE (+)
BREW
B
SPRAY OZ/M: XX.X
(-) DONE (+)
36748 041504