COFFEEBREWING
Start each brew cycle with an empty, clean, half-gallon decanter.
1. Insert a BUNNY filter into the funnel.
2. Pour the fresh coffee into the filter and level the bed of grounds by gently shaking.
3. Slide the funnel into the funnel rails.
4. Place the On/Off brew station warmer switch in the upper position.
5. Momentarily press the start switch.
6. When brewing is completed, simply discard the grounds and filter.
CLEANING
1. The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-0-Matic equipment.
2. Check and clean the sprayhead. The sprayhead holes must always remain open.
3. With the sprayhead removed, insert the deliming spring (provided) all the way into the sprayhead tube.
When inserted properly, no more than two inches of spring should be visible. Saw back and forth five or six
times. Then, repeat this step for the air vent tube.
NOTE - In hard water areas, this may need to be done daily. It will help prevent liming problems
takes less than a minute.
in the brewer and
Page 7
To Next Page
Loading...
