6
53431.1 012618
CLEANING - continued
11. Using supplied brush, thoroughly scrub the faucet body.
12. Allow the parts to soak in the sanitizer solution for a minimum of five
(5) minutes. Remove the faucet parts from the sanitizer solution,
and allow to air-dry overnight.
13. Reassemble faucet.
14. Clean the faucet shank using the supplied brush (00675.0000).
15. Re-install sight gauge seal and sight gauge tube.
16. Re-attach faucet to server shank. When reassembling - USE CAU-
TION: Do Not over-tighten faucet wing nut - HAND TIGHTEN ONLY.
17. Clean the entire outside surface of the server, using a clean SOFT,
Non-abrasive cloth dampened with any mild, non-citrus, non-abrasive,
liquid detergent.
18. Thoroughly rinse the entire server after cleaning.
To Next Page
Loading...
