2
IMPORTANT SAFEGUARDS
Follow these basic safety precautions when using electrical appliances to reduce the risk
of fire, electric shock, and/or personal injury:
s 2EAD ALL INSTRUCTIONS
s $O NOT TOUCH HOT SURFACES 5SE HANDLES
s $O NOT PLACE CORD PLUGS OR BREWER IN WATER OR LIQUID
s #LOSE SUPERVISION IS NECESSARY WHEN THE BREWER IS USED BY OR NEAR CHILDREN
s 5NPLUG FROM OUTLET WHEN NOT IN USE FOR EXTENDED PERIODS OF TIME AND BEFORE CLEANING
Allow to cool before putting on or taking off parts, and before cleaning.
s $O NOT OPERATE THE BREWER WITH A DAMAGED CORD OR PLUG OR IF THE BREWER MALFUNCTIONS
or is damaged in any manner. Return the brewer to an Authorized Service Facility for
EXAMINATION ADJUSTMENT OR REPAIR 2EFER TO PAGE
s 5SING AN ACCESSORY NOT EVALUATED FOR USE WITH THIS BREWER MAY CAUSE INJURIES
s &OR HOUSEHOLD USE ONLY $O NOT USE OUTDOORS
s $O NOT LET CORD HANG OVER EDGE OF TABLE OR COUNTER OR TOUCH HOT SURFACES
s $O NOT PLACE THE BREWER ON OR NEAR A HOT GAS OR ELECTRIC BURNER OR IN A HEATED OVEN
s $O NOT USE BREWER FOR ANY OTHER PURPOSE THAN ITS INTENDED USE
s $O NOT PLACE OR REMOVE FUNNEL OR DECANTER WHILE BREWING
s $O NOT USE THE DECANTER ON A RANGE TOP OR IN A MICROWAVE
s $O NOT SET A HOT DECANTER ON A COLD SURFACE
s $O NOT USE A CRACKED DECANTER OR A DECANTER WITH A LOOSE OR WEAKENED HANDLE
s $O NOT POUR LIQUIDS INTO THE WATER TANK OTHER THAN WATER OR VINEGAR SOLUTION FOR
cleaning, as specified in this manual.
s $O NOT CLEAN DECANTER WITH CLEANSERS STEEL WOOL PADS OR OTHER ABRASIVE MATERIALS
s 7HEN THE BREWER IS IDLE THE LID SHOULD BE IN THE CLOSED POSITION
SAVE THESE INSTRUCTIONS
A short power-supply cord is used to reduce the risks resulting from becoming entangled
in or tripping over a longer cord.
)F AN EXTENSION CORD IS USED THE MARKED ELECTRICAL RATING OF THE EXTENSION CORD SHOULD
be at least as great as the electrical rating of the brewer. The cord should be arranged
so that it will not hang over the edge of table or counter where it can be pulled on by
children or tripped over.
4HE EXTENSION CORD MUST BE A THREEWIRE CORD OF THE THREEPRONGED THREESOCKETED
grounding type (including grounding conductor).
To Next Page
Loading...
