LOWLANDER MK4 MANURE SPREADER – INSTRUCTION & SPARES MANUAL
REMOVING THE SPINNER DECK
1 Clean all material from spinners and decks.
2 Remove 4 bolts from the flexi coupling.
3 Loosen hook bolts No. 14 and hinge back to clear anchors.
4 Using approved lifting apparatus lift from lower lifting eye on the canopy firstly
pulling the bottom of the deck assembly away from rear of spreader to the clear
auger blades.
5 Lift the assembly clear of the spreader and stand on level ground with the front
of the assembly close to, or against a wall or stable object.
6 Fit the shaft cover to the output spigot of the spreader auger gearbox.
7 The machine is now ready for use without spinner deck.
ADJUSTMENT OF CANOPY & BLADES
For the best results
1 Fix the canopy on the inner positions for light materials i.e. Poultry manure.
2 For heavy material i.e. slurry or sludge adjust canopy out as far as possible so as
not to deposit material beyond the deck into gaps between the discs.
3 To increase the width of the spread pattern adjust the angle of blades forward
on the disc.
4 If the spread pattern is light immediately behind the machine adjust the angle of
the blades back.
5 It is possible to achieve an even spread by adjusting the blades, as opposing
pairs. i.e. Blade 1 and 3 position 3 and blade 2 and 4 in position 1.
To Next Page
Loading...
