LOWLANDER MK4 MANURE SPREADER – INSTRUCTION & SPARES MANUAL
ANNUALLY
1. Change oil to all gearboxes.
2. Check the condition of the frame sealing flaps. Replace if not sealing the sides or bottom.
a. Front.
b. Rear Slurry Door Auger Deck.
3. Check brake setting.
Brakes can be checked by depressing the brake petal with the engine running and the
tractor in gear; release clutch to determine brake adjustment.
4. Check condition of rotor blades and paddles. Repair when there are loose bolts, cracked
welds, chipped, bent or broken blades or paddles. Replace when any components are worn
within 25mm (1 inch) of flighting.
5. Clean machine.
6. Check general hardware/bolt tightness. Retighten if necessary.
It is recommended to apply waste oil to the floor chains periodically when spreading dry material
and particularly at the end of the spreading season. This assists in the smooth running of the
machine and prolongs the working life of the components.
7. Check bearings in gearboxes.
8. Remove the floor drive gearbox from drive shaft, clean both, add copaslip to the drive
shaft and gearbox and replace.
2.3 Amount of oil required to fill gearbox
Please use EP90 gear oil
RT500/50/25 6.7 Ltrs (TVA) - 7.75 Ltrs (HBD)
RT800/60/32 10.5 Ltrs (TVA) - 12 Ltrs (HBD)
SRT 12 13.5 Ltrs
SRT 18 13.5 Ltrs
B3183 HDB all in one g/box 16 Ltrs
To Next Page
Loading...
