Burcam 506547SS - User Manual

© 2018 BURCAM Printed in Canada 506516
INSTALLATION
INSTRUCTIONS
Please read these
instructions carefully.
Failure to comply
to instructions
and designed
operation of
this system,
may void the
warranty.
Your pump has been carefully packaged at
the factory to prevent damage during shipping.
However, occasional damage may occur due
to rough handling. Carefully inspect your pump
for damages that could cause failures. Report any
damage to your carrier or your point of
purchase.
MODEL
506518SS
AND BY-PRODUCTS LIKE
506547SS
506548SS,
ETC.
JET PUMP
506537SS
506538SS
506541SS
Factory set voltage 115 V
Connecting volatge changing :
Before changing the voltage connection :
A) Ensure the power to the pump is disconnected.
B) Open motor junction box cover.
C) Please select the up knob position for 115 V
or down knob position for 230 V.
D) Connect to appropriate power source.
E) Close motor junction box.
2190 Dagenais Blvd. West
Laval (Quebec)
Canada
H7L 5X9
Tel. : 514.337.4415
Fax : 514.337.4029
info@burcam.com
see us at www.burcam.com

Summary

INSTALLATION INSTRUCTIONS

Jet Pump Instructions

SAFETY INSTRUCTIONS

General Safety Recommendations

Key safety guidelines covering local codes, electrical circuits, and grounding.

Monthly Maintenance Check-up

INSTALLATION STEPS

Step 1: Installation Location

Recommends a clean, dry, well-ventilated location and warns against running the pump dry.

SHALLOW WELL INSTALLATION STEPS

Step 2-4: Well Connections

Step 5-6: Pump Connections

Step 7: Final Checks & Well Points

TANKS INSTALLATION

Step 9: Packaged System Connection

Connects the pump discharge to the tank 'T' for packaged systems.

Air Tank Precharge Procedures

ELECTRICAL INSTALLATION

Step 10: Wiring and Voltage Selection

Explains wiring connections and selecting the correct voltage for the pump.

Pressure Switch Adjustment Guide

REPAIR PARTS

Parts List and Diagram

Lists all available repair parts with reference numbers and an exploded view diagram.

TROUBLE SHOOTING GUIDE

Troubleshooting Checklist

Provides a checklist of common problems, their probable causes, and recommended actions.

Burcam 506547SS Specifications

General

Model	506547SS
Type	Submersible Sump Pump
Horsepower	1/2 HP
Voltage	115V
Material	Stainless Steel
Cord Length	10 ft
Phase	1
Discharge Size	1 1/2 inches
Switch Type	Vertical Float Switch