ii
SAFETY PRECAUTIONS
As Burford
®
Corp. strives to promote safety in the maintenance and operation of Burford
®
equipment, we request that the following safety procedures be followed, along with any
additional safety procedures set by the customer’s in-plant safety officers or local codes.
1. Read the manual completely before attempting installation or operation of this unit.
2. This machine may contain programs that are password protected. Contact your
supervisor or Burford
®
Corp. for password.
3. Incoming electrical power must be properly shielded, routed, and grounded. All
safety codes should be followed. Study wiring diagrams before attempting
installation.
4. Disconnect power to equipment before removing any guards or covers. Replace
guards or covers before resuming operation of the unit.
5. Loose clothing, jewelry and long hair should be considered a safety hazard around
mechanical equipment. Ensure that they will not be entangled in the equipment.
6. Keep clear of moving machine parts. Bodily harm and/or serious injury may result
from contact with moving gears, sprockets, chains or pneumatically controlled
machine components.
7. Do not bypass safety switches.
8. Do not attempt repairs while equipment is running.
9. Use only original equipment parts designed to safely operate in the equipment.
10. Only authorized personnel should be allowed to operate or perform maintenance on
the unit.
11. This unit is not washdown ready. Do not wash the unit or any of its electrical or
mechanical components, with any form of high pressure or running liquids.
To Next Page
Loading...
