Burke TRI-FLEX II Operating Instructions

3
EXPLANATION OF SYMBOLS USED ON THIS DEVICE
SYMBOL EXPLANATION
Turns unit On/ Off
MODE
Low Air
Loss
Max
Inate
POWER
Max Inate
Low-Air-Loss
Therapy
Time
Upright
LOCK
SOFT FIRM
Therapy
Time
Power Fail
!
Low Pressure
!
!
AP
ALARM
SCILENCE
MODE
Low Air
Loss
Max
Inate
Risk of electrical shock, do not remove back cover
Not for use in presence of ammable anesthetics.
Indicates that the degree of protection against
electrical shock is TYPE BF.
Attention: Instructs end user / care giver / operator
to refer to the manual
Indicates the point of attachment of the equipment
to earth (Grounding Point)
Mutes audio alarm
In the event of power failure or if the hose is
disconnected an audio /visual alarm will sound
Locks out all control unit functions to prevent
patient settings tampering
Boosts air pressures in the mattress to avoid
patient bottoming out
Sets Alternating Pressure Therapy times, 5, 10,
15, 20 minutes
Selects Static, Alternating Pressure (AP) therapy
or Upright (Fowler) mode
Supplies air into the low air loss section of the
mattress or into the optional special multi-cham-
ber air distribution layer in the top sheet
Inates mattress rapidly (30 minute timer)
Up or Down key adjusts patient comfort pressure levels.
Recycle waste electrical & electronic equipment

Burke TRI-FLEX II Specifications

General

Brand	Burke
Model	TRI-FLEX II
Category	Medical Equipment
Language	English