5
SUPPORT SURFACE (B)
Figure - 1 page 14
• Self contained mattress replacement system (B) with easily detachable components
for cleaning.
• Detachable urethane coated, 70 Denier nylon taffeta, ame retardant / water repellent,
mildew resistant, low friction and low shear, 5” (13cm) high (inated) detachable
lateral tubular air cushions (T) (pg.20).
• Detachable urethane coated nylon constant air pressure safety side air bolsters enable
the mattress to be reduced in width to allow easy patient transport in the bed. Side
bolsters can also be deated for easy patient access into and out of the mattress, and
also other easy patient procedures.
• Detachable zippered highly breathable urethane coated, 70 Denier nylon, ame
retardant / water repellent, highly vapor permeable, anti-microbial, low friction and low
shear quilted reusable top covers a Special multi-chambered air distribution layered
low air loss top sheet (E) which administers low air loss relief directly underneath the
patient. 1” (3cm) convoluted safety foam enclosed in the base (C) to support the patient
in the event of loss of air pressure in the mattress.
• The mattress hose assembly has a quadruple tubing (V) with four easy to use quick
connect and disconnect connectors (R) enclosed in a single Plastic housing. The
mattress can be disconnected from the unit by simply squeezing and pulling the release
button on the two quick connectors of the single piece hose connector.
To Next Page
Loading...
Need help?
General
