4 Channel Mode This option allows you to use both, the MAIN and RECORD level, as one preamp. The
RECORD level will be deactivated and the power amp connected to the RECORD output
will reproduce the signals of the MAIN level input. When activated both, the MAIN and
RECORD level, will reproduce the signal from the selected input. If the 4 Channel Mode is
activated, another menu item in THE MAIN SETUP, the FADER, will be available. Please
refer to THE MAIN MENU to see further instructions on the FADER option.
Select menu item 4CH-MODE with the left rotary switch or the navigation buttons
on
your remote control.
With the right rotary switch or the navigation buttons
on your remote control you may
select one of the following:
OFF 4 Channel Mode is deactivated
ON 4 Channel Mode is activated
PLEASE NOTICE: If the RECORD level was set to FIX before the 4 Channel mode had
been activated, the security request REC-FIX! OK? will appear on the display when
the 4 Channel Mode shall be deactivated. You have to confirm the security request by
pressing the OK button on your remote control. Now the 4 Channel Mode is
deactivated.
CAUTION: In this case the RECORD output will be set to FIX after leaving the
GLOBAL MENU. You must disconnect your power amps from the RECORD output
beforehand, because the maximum volume resulting from this setting may cause
severe damage to your power amps, speakers and ears! If the RECORD level was set
to variable before the 4 Channel Mode was activated, it will remain variable after the 4
Channel Mode has been deactivated.
4 Channel Mode Normal Mode
To Next Page
Loading...
Need help?
General
