Burmester 218 - Bi-Amp Mode Introduction

30| 46
OPERATION MANUAL
BIAMP MODE
For bi-amp mode, you need two 218 power amplifiers to play a stereo signal.
Bi-amp mode is possible if your loudspeakers have separate connections for low
and mid-high frequencies.
In bi-amp mode, the particularly important mid-high range benefits directly
from the fact that the relevant power amplifier channels are unburdened by the
power-intensive low range. This leads to a significantly improved imaging and
a more precise locatability of voices and instruments.
For bi-amp mode, use one Burmester bi-amp adapter per amplifier.
Ask your dealer for more information.
ATTENTION! For bi-amp mode, make sure to remove the connection
jumpers between the low frequency and med-high frequency paths at your
loudspeakers! Otherwise, your amplifiers and your loudspeakers may
be damaged.
When connecting, also observe the operation manual for your loudspeakers.
There are two different connection variants for bi-amp mode,
which are described below.