20| 28
OPERATION MANUAL
CONDITIONER BUTTON
Pressing the conditioner button (6) switches the power conditioner’s automatic DC
compensation on and off. The conditioner LED (1) indicates when this function is
active. The DC voltage figure shown on the display (3) will be reset to zero.
AC DC BUTTON
Pressing the AC•DC button (10) toggles the power conditioner’s display (3)
between showing the mains voltage (AC•DC LED (5) off) and the DC component of
the mains voltage (AC•DC LED (5) on).
DISPLAY BUTTON
The power conditioner’s display (
3
) can be switched off using the display button (
9
).
All of the device’s functions will still remain active. Pressing the display button (
9
)
again will turn the display back on.
REMOTE INPUT
The REMOTE input terminal (19) is located on the rear panel of the device,
beneath the AC input terminal (14). This input enables you to switch the 948 power
conditioner on and off from your preamplifier or digital-to-analogue converter.
This function is only available when the power conditioner’s REMOTE input terminal
is connected to the REMOTE output terminal of the preamplifier or the digital-to-
analogue converter via a suitable cable. Please note that we do not include this
remote cable in the scope of delivery because the required cable length varies for
each individual customer. You can obtain a cable of the required length from your
authorised Burmester dealer.
The devices that are connected to their respective AC outlets will be turned on at
the same time. The markings on the rear panel indicate which AC outlets the remote
on/off function needs to be connected to (SWITCHED). In the standard version,
the remote function only switches the power conditioner on and off.
For other remote on/off function options, please contact your authorised dealer.
To Next Page
Loading...
