16| 28
OPERATION MANUAL
Connecting the Device
CONNECTING THE DEVICE
Make sure the AC mains switch (13) is set to OFF. Connect the power cable’s device
plug to the AC input terminal (14). Then plug the mains plug into the wall outlet.
In order to ensure optimum listening pleasure, you should connect the side of the
mains plug that is marked with a dot, to the 'hot' phase of the wall outlet. The 'hot'
phase is also marked with a dot on the 948’s AC outlets. If you are having difficulty
finding the 'hot' phase of your AC wall outlet, please contact your authorised dealer.
CONNECTING THE EQUIPOTENTIAL BONDING CONDUCTOR
In order to ensure that it is safely connected to the earth when discharging
overvoltages, this device is equipped with an additional equipotential bonding
conductor.
This equipotential bonding conductor is required for the safe operation of the 948.
Connect the conductor to the 948’s earth connection (20) by simply plugging it in,
then connect the mains plug on the equipotential bonding conductor to a wall outlet.
All the connection terminals are located on the rear of the device. All components of
the music system must be switched off before connecting the device.
To Next Page
Loading...