21| 28
ERROR PROTECTION
The 948 is equipped with various protection circuits that are designed to protect it
and the devices connected to it in case of a failure.
OVERHEATING
If the device exceeds the maximum permissible operating temperature,
the overheating protection will automatically switch off the DC compensation.
This TEMP LED (8) will light up to indicate this event, while the conditioner LED (1)
will go out.
Once the unit has cooled off, the DC compensation can be reactivated by pressing
the conditioner button (6). The 948 will not allow you to switch it back on until the
temperature has dropped below the maximum permissible limit.
OVERVOLTAGE PROTECTION
The 948 contains overvoltage elements that restrict overvoltages with peak surges
of up to 20,000 A.
To Next Page
Loading...