BURNiT Pell Easy series - Page 32

32
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
Table 7
Possible error codes
Displayedon
controllerscreen
Code
Problem
causes
Problem
soluon
“No fuel” icon
is on
----
Appears upon lack of fuel Fill up the fuel bunker.
Restart controller from the
ON/OFF key.
“Cleaning” icon
ashes
“Cleaning” icon
is on
А003
----
Firebox or ue are polluted and
need cleaning.
Excess ash or unburned fuel in
the rebox.
Check and clean the re-
box or contact your install-
er to
clean the ue.
Икона “Сервиз”
премига
А004
Controller baery low on charge Contact your service for
replacement.
Икона “Сервиз”
премига
А005
Fan encoder fault Contact your service.
Икона “Сервиз”
премига
А007
Boiler door open longer than 1
minute in operaon mode
Close the door and restart
the boiler from the ON/
OFF key.
“Service” Icon
is on
Е001
Display screen error Contact your service.
“Service” Icon
is on
Е004
Display-controller communica-
on error
Contact your service.
“Service” Icon
is on
Е101
Ignion failed, high temperature
in the water jacket of the boiler
Contact your service.
“Service” Icon
is on
Е102
The chimney, the intake air pipe
or the boiler burner are blocked.
Contact your service.
“Service” Icon
is on
Е106
Defecve or non-contacng
buer sensor.
Contact your service.
“Service” Icon
is on
Е108
Overheang of the boiler or
back burning.
Restart the STB thermo-
stat on the rear panel.
“Service” Icon
is on
Е109
Open door sensor error Contact your service.
“Service” Icon
is on
Е110
The room temperature sensor is
defecve / not connected.
Contact your service.
“Service” Icon
is on
Е111
The exhaust sensor is defecve
/ not connected.
Contact your service.
“Service” Icon
is on
Е113
Excessively high exhaust
temperature. Boiler cleaning is
required.
Contact your service.
“Service” Icon
is on
Е114
Ignion failed. Check the fuel
level.
Contact your service.