Burster 9181 - Page 6

FRONT-PANEL FUNCTIONS IN RUN MODE
B
A
TARE
HOLD LIMI
T
MA
X
MIN DATA
DSP2INP2 FL
T
STORE
DSP1
INP1
2
1
4
3
TARE
RESE
T
LI MI T MAX/ MI N DATA
ES
C
EN T E
R
PROG
TEACH
PR
G
RU N
TARE KE
Y
Takes the display value as
Tare.
RUN LED
RUN mode indication
RESET KE
Y
Reset the max, min and tara values.
A
UXILIARY DISPLA
Y
Positive " " or
negative "-" signal
LIMIT KE
Y
Shows at each press the programmed
setpoints value.
LED MAX
Indicates the maximum value read.
LED MIN
Indicates the minimum reading value
MAIN DISPLA
Y
Reads the input variable
LED 2
Indicates activation/display
setpoint 2
LED 1
Indicates activation/display
setpoint 1
KEYBOARD IN RUN MODE
LED 3
Indicates activation/display setpoint 3
LED 4
Indicates activation/display setpoint 4
LABEL
Engineering unit
MAX/MIN KE
Y
Show in each press, maximum value,
minimum value or peak to peak measured
value.
DATA KE
Y
Show data.
Change to PROG. mode
6
TARE LED
Indicates Tare in memory
HOLD LED
Indicates lock read in display
LED LIMIT
Indicates the display of the
setpoint values.
26
This menu allows selection among 4 levels of display rounding. When resolution is not critical, a rounding increment higher than 1,
may help to stabilize the display.
MENU 2AB - ROUND FILTE
R
Program the rounding increment, LED FLT activated.
T
he display shows the previously selected round level. To change this parameter,
press repeatedly the
key to rotate around the different options : [01 = no
rounding, 02 = round to 2 counts, 05 = round to 5 counts, 10 = round to 10 counts].
ENTER
To save the option present on display and return to the run mode.
ESC
To exit from the programming mode without saving changes.
[26.2] Rounding increment
B
A
TARE
HOLD LIMIT MA
X
MIN DATA
DSP2INP2 FL
T
STORE
DSP1
INP1
2
1
4
3
TARE
RESET LIMIT MAX/MIN ENTE
R
ES
C
DATA
PROG
TEACH
PR
G
RUN
The figure 26.1 shows the indication (round) corresponding to the round menu. Press
ENTER
to acceed the configurations.
ENTER
To get access to the round level selection.
To Skip over this menu and pass to the next one.
ESC
To exit from the programming mode without saving changes.
[26.1] Round filte
r
B
A
TARE
HOLD LIMIT MA
X
MIN DATA
DSP2INP2 FL
T
STORE
DSP1
INP1
2
1
4
3
TARE
RESET LIMIT MAX/MIN ENTE
R
ES
C
DATA
PROG
TEACH
PR
G
RUN