71Belcanto/Trecento - 10/11 - Ausgabe 07/10 - 1976844 - BUE-0042-06EN
7.3 Changing gas bottles
Open external gas bottle compartment (see chapter 6).
Close the regulator tap (Fig. 84,1) on the gas bottle (Fig. 84,2). Pay atten-
tion to the direction of the arrow.
Unscrew the gas tube (Fig. 84,3) by hand from the gas bottle.
Release the fixing belts and remove the gas bottle.
Place a filled gas bottle in the gas bottle compartment.
Fix gas bottle in place with the fixing belts.
Screw gas tube on gas bottle by hand.
Use the shortest possible tube lengths (150 cm max.) for external gas
bottles.
Never block the floor ventilation openings below the gas bottles.
For gas-operated units the gas pressure must be reduced to 30 mbar.
Connect gas pressure regulator complete with safety valve directly to bottle
valve.
The gas pressure regulator reduces the gas pressure in the gas bottle
down to the operating pressure of the gas devices.
For filling and connecting the gas bottles in Europe the accessories shops
have corresponding Euro filling sets and Euro bottle sets.
Information available at the dealers or service centre.
For information on the gas supply in Europe see chapter 17.
When changing gas bottles, do not smoke or create any open fire.
When you have changed the gas bottle, check whether gas escapes at
the connection points and unions. Use a leakage search spray to spray
the relevant connection point or union. These agents are available at the
accessories shop.
Fig. 84 Gas bottle compartment
To Next Page