EasyManua.ls Logo

Burstner Trecento 2011 - 230 V Power Supply and Connection

Burstner Trecento 2011
208 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
83Belcanto/Trecento - 10/11 - Ausgabe 07/10 - 1976844 - BUE-0042-06EN
Electrical system
8
8.6 230 V power supply
The 230 V power supply provides electricity for:
sockets with earth contact for appliances with maximum 16 A
refrigerator
power pack or power supply unit
The electrical appliances connected to the 12 V power supply of the living area
are supplied with voltage by the power pack, power supply unit or living area
battery (if available).
Connect the vehicle to an external 230 V power supply system as often as
possible. If a living area battery is installed, this is automatically charged via a
charger module.
8.6.1 230 V connection
The vehicle can be connected to an external 230 V power supply. The cable
may have a length of maximum 25 m.
8.6.2 Power cable for external 230 V connection
Power cable
Three-core (3 x 2.5 mm
2
) flexible rubber sheathed cable
Maximum 25 m in length
1 plug with earth contact
1 socket with earth contact (plug-in devices according to EN 60309)
Connection possibilities For your power cable, we recommend using a CEE connection cable with a
CEE plug and coupling. If this type of connection is not feasible, we recom-
mend the following combination with a safety plug:
Only allow qualified personnel to work on the electrical system.
The external 230 V power supply must be protected by fuse with a fault
current protection switch (FI-switches, 30 mA).
Always disconnect the electrical connection between the towing vehicle
and the caravan before the caravan is connected to the local power supply.
In order to carry this out, disconnect the plug from towing vehicle socket.
For the connection points on camp sites (camping distributors) highly sen-
sitive fault current protection switches (FI-switches, 30 mA) are obligatory.
The vehicle is already already equipped with a fault current protection
switch (FI-switch).
Completely unwind the cable on cable drums to prevent overheating.

Table of Contents