R
43
Basic Calibration
In the following section [<] or [>] is used to vary the number entered.
[BASE] Select mode [CAL]
[<], [>] Adjust value [<], [>]
[BASE] Select previous value [CAL]
[ENTER] [ENTER]
Batch Mode
[SETUP] Select mode
[<] or [>] Scroll through batches
[ENTER] Select batch
Batch Clear
[SETUP] [ENTER] [CLEAR] [ENTER] [ENTER]
To clear current batch
[SETUP] [ENTER] ([<] or [>]) [CLEAR] [ENTER] [ENTER]
To clear specified batch
[SETUP] [ENTER] ([<] or [>] to Batch 0) [CLEAR] [ENTER] [ENTER]
To clear all batches
To Next Page
Loading...