How to troubleshoot a BUSCH Water Pump that does not start?
If your BUSCH Water Pump is not starting, there are a few potential causes. Ensure that the motor is receiving the correct voltage by checking the power supply. If the power supply is adequate, the motor itself may be defective and require replacement. Another possibility is a defective coupling, which would also need to be replaced.
Why is my BUSCH R5 fuming or expelling oil?
If your BUSCH Water Pump is fuming or expelling oil droplets through the gas discharge, the exhaust filters may be partially clogged and need replacement. Also, ensure that the exhaust filter with o-ring is fitted properly. Check the float valve and the oil pipe for any clogging and remove it. If you have a version with an oil return valve and the machine runs for more than 10 hours without interruption, regularly shut down the machine for short periods of time.
What causes a BUSCH Water Pump to run very noisily?
If your BUSCH Water Pump is running very noisily, it could be due to a worn coupling, which would need to be replaced. Alternatively, the vanes could be stuck, or the bearings could be defective. In either of the last two cases, contact Busch to repair the machine.
Why the oil in my BUSCH R5 is black?
If the oil in your BUSCH Water Pump is black, it could be due to oil change intervals being too long. In this case, contact Busch to flush the machine. Another possibility is a defective inlet filter, which should be replaced. Also, the machine might be running too hot.
What to do if the oil in my BUSCH R5 Water Pump is emulsified?
If the oil in your BUSCH Water Pump is emulsified, it might be because the machine sucked in liquids or significant amounts of vapour, in this case, contact Busch to flush the machine. You should also clean the filter of the gas ballast valve. Consider modifying the operational mode.
What to do if my BUSCH Water Pump does not start?
If your BUSCH Water Pump doesn't start, first check the power indicator light to ensure the unit is receiving power at the correct voltage by checking the power supply connection. If the power is on but the touchscreen or PLC isn't running, verify the 24V power supply. If the machine has reached a limit operating value, identify and solve the problem listed in the menu “HOME” > “WARNING/ALARM”. Also, the motor or the coupling could be defective and may need replacement.
What to do if my BUSCH R5 Water Pump does not reach the usual pressure on the suction connection?
If your BUSCH Water Pump isn't reaching the usual suction pressure, it could be due to several reasons. Check the oil level and top it up if it's low. The inlet filter cartridge might be partially clogged and require replacement. If these steps don't resolve the issue, internal parts may be worn or damaged.
Why is the oil emulsified in my BUSCH R5?
If the oil in your BUSCH Water Pump is emulsified, it's likely that the machine sucked in liquids or significant amounts of vapor. In this case, flush the machine (contact Busch).
Why is my BUSCH R5 Water Pump running very noisily?
If your BUSCH Water Pump is running very noisily, it could be due to a worn coupling, which would need to be replaced. Alternatively, the vanes could be stuck, or the bearings could be defective.
Why does my BUSCH R5 Water Pump fume or expel oil droplets through the gas discharge?
If your BUSCH Water Pump is fuming or expelling oil droplets, the exhaust filters may be partially clogged and require replacement. Also, ensure the exhaust filter with o-ring is correctly positioned. Another potential cause is a malfunctioning float valve; check it and the oil return line.
General| Brand | BUSCH |
|---|---|
| Model | R5 |
| Category | Water Pump |
| Language | English |
To Next Page
