14
Select the operating mode using one of the remote control mode buttons (LINE IN, OPTICAL) until the
indicator corresponding to the sockets being used is illuminated. Repeated pressing of the
button on the soundbar can also be used. The unit also gives an audio announcement of the
POWER /
Using your soundbar
Let’s get started
Using the soundbar via wired connection
Connect the equipment to the soundbar as described above and insert the adaptor cable into the DC jack at
the rear of the soundbar. Pl ug into the mains supply and the red standby indicator light will illuminate to
Press the remote control POWER ( ) button to switch on the unit or press and hold POWER / SOURCE
Adjust the volume to the des
ired level by pressing the VOLUME (+ or -) buttons until the desired listening
Press play on the connected equipment.
volume is achieved. The sound can be silenced by pressing the MUTE button, the sound will be silenced and
the indicator will flash on unit to indicate that the sound has been muted. Press the MUTE button
a second
time to restore the sound.
If desired, use one of the sound equalizing buttons
(MUSIC, MOVIE TALK, STANDARD) to optimize the tone of the
sound being listened to. See guide below. The indicator will flash once when the
button is pressed to
show that the function has been selected.
MOVIE – Bass and Treble boosted, for more dramatic sounds.
TALK – Midrange boosted, bass and treble cut to make speech programmes clearer.
MUSIC – Level frequency response.
STANDARD - Sound in stand
ard mode.
Use the controls as usual on the connected equipment.
To place the soundbar into standby mode press the POWER ( ) button on remote control or press and hold
and the red standby indicator will
illuminate.
9.
8.
7.
6.
5.
4.
3.
2.
1.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions
show that the soundbar is in standby mode.
button on soundbar.
source
POWER / SOURCE button on unit
Note : This product is designed to go into STANDBY mode automatically after 20 minutes
(approximately) if it does not receive an audio signal. To switch soundbar back on press POWER ( )
button on remote control or press and hold POWER / SOURCE button on unit.
Note: There are 32 volume levels. The indicator will flash at each press of VOLUME (+ or -) until
mimimum or maximum volume level has been reached and indicator remains illuminated.
Note : In Optical mode mark sure the audio settings are set to PCM or Optical Audio on your connected
device and are turned On.
selected mode.
SOURCE
,
To Next Page
Loading...
