Bush B-3363A - Bluetooth Connection

Pairing a Bluetooth device
Before you can use the soundbar with your phone or
other Bluetooth capable device you will need to pair
the device to the soundbar.
Pairing a Bluetooth Device for the First Time
1. Press and hold 2 seconds the POWER/SOURCE
button on the unit or the POWER button on the
remote control to switch on the unit.
4.
5. When successfully paired and connected, an audio
announcement will issue from the unit and the
indicator will display a solid blue light. After initial
pairing, the unit will stay paired unless unpaired
manually by the user or until it is erased due to a
reset of the device. If your device should become
unpaired or you find it is unable to connect, repeat
the above steps.
Controlling a paired device
Once connected you can either use the controls on
the audio device to begin playback, skip tracks etc.
Or you can use the control buttons on the remote.
1. The
button on the remote control when
2. To skip to the next track press the
button
on the remote.
3. To skip to the previous track press the
button on the remote.
4. Any further operations must be done from the
audio device.
The v
ected by the volume level
on the audio source EG: Phone or laptop, so make
sure that is set to about 70-80% ( not too loud to
avoid distortion).
Bluetooth notes
• The operation range of Bluetooth is approximately
10 metres (30 Feet). Any obstacles in the path
between devices may reduce this range.
• Only one Bluetooth device can be paired at a time.
• Not all Bluetooth devices are compatible.
15
2.
Select and press the Bluetooth ( ) SOURCE
button on
the
remote control to
Bluetooth mode or press the POWER/
button on the unit repeatedly to enter
indicated by the blue indicator
that will flash whilst
the unit searches for
3.
On the device that you would like to connect to
your soundbar via Bluetooth (e.g. TV/phone/
tablet/computer), turn on Bluetooth
connectivity and ensure that it is 'discoverable'.
When connecting a device via Bluetooth,
remain within 3 feet of the soundbar.
Note: If necessary, refer to the instructions for
your device to add or set up Bluetooth.
enter
SOURCE
Bluetooth mode
light
Bluetooth devices.
When found on your device your soundbar will
be displayed as 'Bush B-3363A'. Select this name
on your device to begin pairing.
Or by calling one of our experts on
0345 6040105
Using the soundbar with a Bluetooth device
pressed will begin playback of the selected
track on the audio device. Press again to
pause playback.