Bush B-3515A - Pairing a Bluetooth Device; Controlling a Paired Device; Bluetooth Notes

Using your Soundbar
Let’s get started
Using your Home Theatre
14
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Pairing a bluetooth device
Before you can use the soundbar with your phone or
other bluetooth capable device you will need to pair
the device to the soundbar.
Pairing a Bluetooth Device for the First Time
1. Press and hold 2 seconds the POWER/SOURCE
button on the unit or the POWER button on the
remote control to switch on the unit.
2. Press the BLUETOOTH button on the remote
control to enter Bluetooth mode or press the
POWER/SOURCE button repeatedly to enter
Bluetooth mode, The mode indicator LED will
turn blue.
3. Press the PAIR but
ton on the remote control or
the unit directly. The mode indicator LED will flash
quickly. When pairing, remain within 3 feet of
the unit.
4. Using the native controls on your Bluetooth
device, select device “ Bush B-3515A ” in your
settings to pair.
5. When successfully paired and connected, a beep
will issue from the unit and the mode indicator
LED will display a solid blue light. After initial pairing,
the unit will stay paired
unless unpaired manually
by the user or until it is erased due to a reset of
the device.
If your device should become unpaired or you
find it is unable to connect, repeat the above
steps.
Controlling a paired device
Once connected you can either use the controls on
the audio device to begin playback, skip tracks etc.
or you can use the control buttons on the remote.
1. The
button on the remote control or PLAY/
PAUSE on unit when pressed will begin playback
of the selected track on the audio device. Press
again to pause playback.
2. To skip to the next track press the
button
on the remote.
3. To skip to the previous track press the
button on the remote.
4. Any further operations must be done from the
audio device.
The v
ected by the volume level
on the audio source EG: Phone or laptop, so make
sure that is set to about 70-80% ( not too loud to
avoid distortion).
Bluetooth notes
• The operation range of bluetooth is approximately
10 metres (30 feet). Any obstacles in the path
between devices may reduce this range.
• Only one Bluetooth device can be paired at a time.
• Not all Bluetooth devices are compatible.
Bluetooth
__________________________________________________________________________________________________________________________
Note: There are 40 volume levels. The LED indicator will flash at each press of VOL+ / VOL- until
mimimum or maximum volume level has been reached and LED indicator remains illuminated
__________________________________________________________________________________________________________________________