Bush BAS520BT - FM Mode; Selecting FM Mode; Scan Setting; Audio Setting

BAS520BT
10
FM Mode
Selecting FM Mode
1. Press SOURCE button repeatedly to select FM mode.
2. For initial use, it will start at the beginning of the FM frequency range (87.50MHz). Or it
will play the last FM station you were listening to.
3. To manually change the FM frequency, while FM frequency shows up, press TUNE
button first and then press or button to change the frequency by 0.05MHz per
step.
4. To automatically scan, while FM frequency shows up, press TUNE button first and then
press and hold or button, your unit will skip backwards or forwards until it
reached the next available station.
Scan Setting
By default, FM scans stop at any available station. This may result in a poor signal-to-noise
ratio (hiss) from weak stations.
1. To change the scan settings to stop only at stations with good signal strength, press
MENU button and then press or button to select Scan setting, press
SELECT button to confirm.
2. Press or button to browse ‘Strong stations only’, and then press SELECT
button to confirm.
Audio Setting
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a
poor signal-to-noise ratio (hiss).
1. To play weak stations in mono, press MENU button and then press or
button to select Audio setting, press SELECT button to confirm.
2. Press or button to browse ‘Forced mono’, and then press SELECT button to
confirm.