Installing your Freestanding Cooker
Bringing it all together
Installing your Freestanding Cooker
16
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Electrical connection
IMPORTANT: Electrical connections must be
carried out by a suitably qualified person and
in accordance with all relevant local building
and installation regulations.
1. See the rating label at the rear of the product
for the appliance’s load rating.
2. The cooker must be connected to a dedicated
circuit suitably rated for the load of the
appliance (see rating label at rear of
appliance) . It must be connected via a
suitably rated cable to a double pole isolator
cooker switch also suitably rated for the
appliance.
3. The electrical cable should not touch the hot
parts of the appliance. .
The electrical cable (not supplied) should
not be routed through any area that may be
affected by heat from the oven, especially
the area directly behind the oven.
To Next Page
Loading...
