Bush CDV-03965 - Getting started; Adjust the volume; Mute; Controls during playback

Using your DVD Player
Let’s get started
Using your DVD Player
18
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Getting started
1. Check that you have correctly connected all
the cables and have installed the batteries in the
remote control.
2. Switch on your TV/Monitor and check that it is set
to the correct input, which for this DVD Player is
HDMI, SCART.or RCA phono/CVBS (composite
video).
3. With the DVD Player in Standby mode, press the
Power button on the DVD Player or the STANDBY
button on the DVD Remote control to turn the
product on. The LED on the front right of the DVD
Player will change to green.
4. Press the Open/Close button on the DVD
Player or on the remote control to open the DVD
drawer.
5. Place the disc that you wish to play, label side up,
on the DVD tray. Please ensure that the disc is
laying flat within the recessed disc shaped area on
the tray.
6. Press the Open/Close button to close the
drawer. The disc will start to play.
Adjust the volume
Volume +
Press and release to increase the volume in steps.
Press and hold to progressively increase the volume.
Volume -
Press and release to decrease the volume in steps.
Press and hold to progressively decrease the volume
Note: To gain optimal volume levels, adjust the
volume on both the DVD Player and on the TV.
Mute
Press the Mute button to turn off the sound.
Press the Mute button again to turn the sound back
on again.
Controls during playback
Play/Pause
Skip back
Fast backward
Skip forward
Fast forward
Stop - Press once to pre-stop, Your DVD Player
will remember the place where the disc was stopped.
Press the Play/Pause button to resume playback
from this point. Press the Stop button twice to stop
play completely.
Repeat play (DVD/CD/JPG)
DVD
If available on your DVD disc, your DVD player has
repeat options of CHAPTER, TITLE, REPEAT ALL and
OFF.
1. Repeatedly press the REPEAT button to display
and activate each available option.
CD
If available on your CD disc, your DVD player has
repeat options of REPEAT 1 (single track) and REPEAT
ALL (repeats all the tracks on the disc) and REPEAT OFF.
1. Repeatedly press the REPEAT button to display
and activate each available option.
Note: Some discs may not allow repeat functions.
JPG images
Your DVD player has repeat options of
• REPEAT 1 (single image)
• REPEAT DIR (repeat all images in a folder)
• REPEAT ALL (to repeat all images on the disc)
• REPEAT OFF.
1. Repeatedly press the REPEAT button to display
and activate each available option.