Bush DLED50273FHDCNTD - Network Configuration Settings

For any help concerning set up and use of your TV please call the Customer Helpline: 0 345 604 0105
Connectivity Functions
Conguring Network Settings
Your TV’s Network Settings include Wired and
Wireless Connection options.
Conguring Wired Device Settings
If you are connecting the TV via ETHERNET
INPUT, select Network Type as Wired Device
to congure.
Network Type
Network type can be selected as Wired or
Wireless device, in accordance with the active
connection to the TV set. Select this as Wired
if you have connected to the TV a LAN cable.
Select as Wireless if you connect wirelessly.
Conguration Status
This section displays the status of the connection.
IP Address
If an active connection is available, the IP address
will be displayed on this section. If you want to
congure IP address preferences, press GREEN
button and switch to the advanced mode.
Conguring Wired Network Settings in
Advanced Mode
After pressing GREEN button, Advanced mode
will be available. While in Advanced Mode, press
RED button to edit settings. When nished, press
OK to save, Press RETURN/BACK to cancel.
Configuring Wireless Device Settings (Optional)
Wi-Fi feature can be used for a wireless network
connection. The feature is used for infrastructure
purposes only, such as connecting to the web,
hbb sites and connecting with DLNA servers
(optional). Select Network Type as Wireless
Device to start connection process.
Press YELLOW button to scan wireless network
from network settings menu. Afterwards,
available network list will be displayed. Please
select your desired network from the list.
If the selected network is protected with a
password, please enter the correct key by using
the virtual keyboard. You can use this keyboard
via navigation buttons (Left/Right/Up/Down)
and OK button on the remote control.
Wait until the IP the address is shown on the
screen.
Press GREEN button to switch to advanced mode
and then press OK button to edit settings. This
means that the connection is now established. To
disconnect from a wireless network, you should
highlight Conguration Status and press OK.
41