18
EN
If you have damaged or missing parts,
call the Customer Helpline: 0345 257 7271
Before cleaning your washing machine.
a: Unplug your machine from the mains power
supply.
b: Close the water tap.
Water inlet filters
and at the ends of water inlet valves, there are filters
to prevent entrance of the dirt and foreign materials
in the water to the machine. If the machine is unable
to receive sufficient water although your water tap is
fully opened, these filters should be cleaned.
valves by using a pincer and wash thoroughly with a
brush. (1)
located on the tap side by removing manually
together with the seal. (2)
the same way as you have removed them.
Pump filter
The pump filter system elongates the life of your
pump, which is used to drain the dirty water. It
prevents lint to enter the pump. Cleaning of your
pump filter in every 2-3 months is recommended.
To clean your pump filter:
powder detergent spade (*) or liquid detergent
level plate coming out of your machine. (1-A &
2-A)
of the filter cover to prevent flow of the remaining
water in the machine.
brush and flush with clean water. (3-A)
tighten it by rotating it in clockwise direction.
(4-A)
cover properly, it will leak water.
parts on the inner side of the cover to match the
holes on the front panel side. (5-A)
order that you removed it.
Danger of being scalded!
The water inside the pump
maybe hot- wait for it to cool.
(*) Machinery specifications may vary depending on
the product purchased.
Care and Maintenance
1
1A
3A
5A
2
2A
4A
To Next Page
Loading...
