14
EN
To avoid programme flow from being affected if
programme buttons are pressed or programme
button is turned when performing washing operation
in your machine, child lock is available.
Child lock will be activated in case pressed on both
auxiliary functions 3 and 4 at the same time for
more than 3 seconds. You can see the auxiliary
function leds on the display when activated.
If pressed any button while child lock is active, the
Additional Function Leds will blink on the display.
If while the child lock is engaged and any pro-
gramme is running, the programme knob is
switched to the CANCEL position and another
programme is selected, the programme previously
selected continues from where it left.
To deactivate it, it will be sufficient to press on the
same buttons for more than 3 seconds. When the
child lock is deactivated, the Additional Function
Leds will blink on the display.
If you want to cancel any programme running:
1- Switch the programme knob to “CANCEL” posi-
tion.
2- Your machine will stop the washing operation and
the programme will be cancelled.
3- To get rid of the water accumulated in the
machine switch the programme knob to any pro-
gramme.
4- Your machine will perform the necessary dis-
charge operation and cancel the programme.
5- You can run your machine by selecting a new
programme.
Your machine will stop by itself as soon as the
programme you have selected finishes.
- End led will blink on the display panel.
- You can open the machine’s door and remove the
laundry.
- Leave the door of your machine open to allow the
inner
part of your machine to dry after removing your
laundries.
- Switch the programme knob to CANCEL position.
- Unplug your machine.
- Turn the water tap off.
Introduction of control panel
To Next Page
Loading...
