22
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Party Speaker
Using your Party Speaker
Let’s get started
Power on
After you have connected the power to the Party speaker, press the power switch on
the back of the Party speaker at the top to On. The product will switch on, ‘Hi’ will be
displayed followed by ‘-bt-’, a bluetooth icon will flash to indicate that you Party speaker is
searching for Bluetooth devices.
Standby mode
If the Party Speaker does not receive an audio signal for approximately 20 minutes, it will
go to Standby mode. Short press the Power/M button to turn the product back on
again.
Power o
Long press the Power/M button and then switch the power switch on the back of the
Party speaker to off. To power off the product completely switch off at the mains power
wall socket.
Connect to a Bluetooth device
Check that your Party speaker is in Bluetooth mode. If you are not already in Bluetooth
mode, short press the Power/Mode button until you are in Bluetooth mode (check the
display). Your Party speaker will begin to search for Bluetooth devices.
In Bluetooth Mode:
1. Your Party speaker will search for Bluetooth devices.
2. On the device that you would like to connect to your Party speaker (e.g. iPhone/iPad/
Android/other phone/Tablet/Computer), turn on Bluetooth connectivity and ensure
that it is ‘discoverable’.
Note: If necessary, refer to the instructions for your device to add or set up Bluetooth.
3. Select to ‘Add new device’, if necessary.
To Next Page
Loading...
