How to clear a blockage
If vacuum is not cleaning carpet, or if no suction at end of hose, check
to be sure air path is not blocked.
1. Press release button and lift o dust container (Fig. 1).
2. Empty debris. Hold over wastebasket and press bottom lever to
release bottom lid (Fig. 2).
3. Check filter screen. Remove any debris and shake o dust. (See
maintenance instructions on page 22.)
4. Loosen end of hose.
5. Use a rod or similar blunt implement to clear a blockage in wand or
hose. Flex hose to loosen debris. (Fig. 3). Use caution if there is any sharp
objects that could have become imbedded in hose.
6. Remove dust container.
7. Use finger to check for debris in air path (Fig. 4).
8. Reinstall filters inside dust container and position dust container onto
vacuum cleaner.
Care and maintenance
Looking after your appliance
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting section of these instructions
24
Warning: Never operate vacuum cleaner without foam filter and
filter screen in proper position.
Caution: Make sure vacuum is turned o and power cord is
unplugged.
Caution: Be careful of anything sharp that could have imbedded
or got stuck in the unit when checking!
1 2 3
To Next Page
Loading...
