Bush WM2760DAB - Page 22

Getting to know your Stereo Flat Micro System
22
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshoot ing
Getting to know your Stereo Flat Micro System
You’ll be up and running in no time
6. The duration for your alarm will flash. Use the or buttons on the Micro or the
or buttons on the remote control to set the duration for your alarm, you can
choose from 15, 30, 45, 60, 90 or 120 minutes. Short press the Select button.
7. The sound source for your alarm will flash. Use the or buttons on the Micro or
the or buttons on the remote control to set the sound source for your alarm,
you can choose from Buzzer, DAB or FM radio. Short press the Select button.
Note: If you select DAB or FM for the sound source, ‘Last’ will flash in the display. If
you have set radio station presets these will also be available and you can use the
or buttons on the Micro or the or buttons on the remote control to scroll
through the options available and press the Select button. The last listened to radio
station or radio preset in DAB or FM, as appropriate, will be used for your alarm.
8. Daily will flash in the display. Use the or buttons on the Micro or the or
buttons on the remote control to set the frequency for your alarm. You can
choose from Daily, Once, Weekends or Weekdays. Short press the Select button.
Note: If you select ‘Once’, you will then be prompted to set the date for your alarm.
9. Alarm Volume 9 will scroll in the display. Use the or buttons on the Micro or
the or buttons on the remote control to set the volume for your alarm. You
will not be able to set this for less than Alarm volume level 9. Short press the Select
button.
Note: Remember to set the alarm volume to one that will wake you.
10. On or Off will flash in the display. Use the or buttons on the Micro or the
or buttons on the remote control to choose On or Off. Short press the Select
button.
11. Saved is displayed. A bell icon will appear in the Standby display, together with a ‘1’ or
‘2’ as appropriate, to confirm that an alarm has been set.
Stop the alarm
When the alarm sounds, short press the Power button on the Micro or on the remote
control to turn off the alarm. The alarm will reset for the next day.