Using your Stereo Flat Micro System32
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Tro ubles hooting
Using your Stereo Flat Micro System
Let’s get started
There are now two different options of ‘Mono’ and ‘Stereo’.
2. Use the or buttons on the Micro or the or buttons on the remote
control to choose from the two options available and short press the Select button.
3. Short press the Menu button on the Micro or on the remote control to exit from the
Menu.
Storing an FM station preset
Your Micro can store up to 10 FM radio stations in its preset memories for instant access to
your favourite stations.
1. Tune the Micro to the FM radio station that you wish to preset.
2. Long press the Preset button on the Micro or the Prog. button on the remote control
until Empty 1 is displayed.
3. Use the or buttons on the Micro or the or buttons on the remote
control to move the preset number that you would like to store the radio station to
(Empty 1-Empty 10).
4. Short press the Select button on the Micro or on the remote control to store the
station to that preset location. Stored will be displayed.
Note: If there is already an existing FM station stored under a preset, it will be
overwritten when you store the new station.
Tune to a FM station preset
In FM mode:
1. Short press the Preset button on the Micro or the Prog. button on the remote control.
The name or frequency or a stored station will be displayed, or ‘Empty 1’ if no station
has been stored.
2. Use the or buttons on the Micro or the or buttons on the remote
control to move the preset location and station that you would like to listen to (1-10).
To Next Page
Loading...
