EasyManua.ls Logo

Bush WM2760DAB - Power source; Moisture and water

Bush WM2760DAB
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety information8
Safety information
Important - Please read these instructions fully before
installing or operating
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Tro ubles hooting
Power source
Only use the power supply that came with the product. Using an unauthorised power
supply will invalidate your guarantee and may irrecoverably damage the product.
Disconnect your Micro from the mains power supply during thunderstorms.
Always check that you have completely switched off your Micro System, before you
change or disconnect the power supply.
Where the mains power plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
If the Micro System will not be used for a long period of time, remove the CD and
make sure that the mains power is unplugged and the battery is removed from the
remote control.
Only use recommended batteries or those of the same or equivalent type in the
remote control.
Batteries are to be inserted with the correct polarity.
The supply terminals are not to be short-circuited.
Never throw batteries in a fire or attempt to open the outer casing.
Batteries are harmful if swallowed, so keep away from young children.
Caution:
Danger of explosion if batteries are incorrectly replaced. Replace only with the same
or equivalent type.
Moisture and water
Keep it dry. Avoid exposure to precipitation, humidity and liquids which could all affect
the product circuitry. Do not leave it in low temperatures as moisture can form inside
the product, which may damage the circuit board.

Related product manuals