Using your Stereo Flat Micro System
Let’s get started
Using your Stereo Flat Micro System26
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Tro ubles hooting
DAB Radio Mode
• Check that your Micro is in DAB mode. If you are not already in DAB mode, short press
the Mode button on the Micro or on the remote control until you are in DAB mode
(check the display).
• The first time you use your Micro or if the station list is empty, your Micro will
automatically begin to scan for DAB radio stations. Scan and then after a short delay
the number of stations found during the scan will also be displayed.
• If you were listening to a DAB station when you switched the Micro off, then this
station will automatically be selected when you switch the radio back on.
Wire radio aerial
Please make sure that the wire aerial on the back of the Micro is fully extended and
adjusted before you attempt to tune to a DAB radio station (a vertical position is
recommended). This will ensure that the maximum signal strength is available when the
Micro begins to scan. Extending the aerial also ensures the best possible sound quality.
Changing DAB stations
In DAB mode:
1. Use the or buttons on the Micro or the or buttons on the remote
control to scroll through the available stations.
2. When the station that you would like to listen to is displayed, short press the Select
button on the Micro or on the remote control. There will be a short delay whilst your
Micro tunes to your selected station.
Scanning for DAB stations
With DAB radio, additional stations and services regularly become available so it’s a good
idea to carry out a manual scan every now and then to make sure that you have the most
up to date station listing stored within the memory of your Micro.
If you have moved your Micro to another location, e.g.: if you go on holiday, then it’s also
a good idea to carry out a manual scan.
To Next Page
Loading...
