Using your Stereo Flat Micro System
Let’s get started
Using your Stereo Flat Micro System38
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Tro ubles hooting
3. Select to ‘Add new device’, if necessary.
Note: Some products will automatically search for a new device and so the ‘Add new
device’ option is not available.
4. When found, your Micro will be displayed as ‘BUSH DAB MICRO’. Select the device
name to begin pairing.
5. When pairing is complete ‘BT’ will stop flashing in the display, and will be constantly
displayed.
6. Now that you have paired your device with the Micro, it will connect to it when it is
within range, which is about 10 metres or less (33 feet or less), line of sight.
7. Your device will remain paired with the Micro unless you decide to disconnect or
‘unpair’ it.
Note: If your device should be come unpaired for any reason, follow the steps above to
‘pair’ it again. You can short press the Pair button on the remote control to restart the
Bluetooth pairing process.
Listening to Music/Audio using Bluetooth
In Bluetooth (BT) Mode:
1. Select and start the music or audio that you wish to listen to on your paired Bluetooth
device, it will now be heard through the Micro speakers. Adjust the volume on the
connected device and/or your Micro.
Note: If your previously paired device is within range but does not automatically
connect, go to the Bluetooth connectivity settings on your device and select ‘BUSH
DAB MICRO’ to reconnect. Alternatively, short press the Pair button on the remote
control to restart the Bluetooth pairing process.
2. You can use the controls on your paired Bluetooth device as well as those on the front
of the Micro or on the remote control when listening to music via Bluetooth.
To Next Page
Loading...
