15
Removal: Using 5/64” Allen wrench, loosen the three Allen head set screws two to three
turns. Pull hub cover off of wheel hub.
Installation: Check that the setscrews do not protrude inside hub cover. Place hub cover
over hub of wheel and push on until three internal stops make contact with the hub face.
Using the 5/64” Allen wrench, tighten the three Allen head set screws in an alternating
pattern until snug against the hub of the wheel.
CAUTION: Do not overtighten! Make sure setscrews are snug against hub and pull on
cover to check proper tensioning. Spin the wheel to make sure the hub cover is on
straight and does not contact any other parts.
FORGED WHEEL HUB COVER
TOOLS REQUIRED
3/16” Allen wrench
Removal: Using 3/16” Allen wrench, loosen the single Allen head set screw until almost
removed from hub cover. Pull hub cover off of wheel hub.
Installation: Check that the setscrew does not protrude inside hub cover. Place hub cover
over hub of wheel and push on until fully seated against hub face. Using the 3/16” Allen
wrench, tighten the single Allen head set screw until snug against the hub of the wheel.
CAUTION: Do not overtighten! Make sure setscrew is snug against hub and pull on
cover to check proper tensioning. Spin the wheel to make sure the hub cover is on
straight and does not contact any other parts.
REMOVAL FROM STORAGE
Perform the designated services according to the chart.
MISCELLANEOUS
Tires should be checked for signs of weathering, checking, cracking, or irregular wear. If
tires exhibit any of the above signs or have less than 1/8 inch of tread on the middle of
the tread face, the tires should be replaced.
To Next Page